Custom design
See the project →Seating set: from design to manufacturing
12 monthsWorkmanship & materials warranty
2 working daysFirst assessment from photos
One teamFrom design to fitting
TR · ENQuotes and reports
210×366 cmOur own CNC bed
3D scanningExact measurements on board
What we do
From tenders to superyachts: we work on board and make the parts in our own workshop.
Teak decks
Full decks, swim platforms and stairs. We measure the remaining teak first and tell you in writing whether it needs renewal or repair.
Learn more →
Custom design
Seating, boarding ladders, cabinets and stainless parts. Drawn in 3D first, then built in our own workshop once you approve.
Learn more →
Composite
A broken or lost part? We scan the opening, make the mould and build a new one. Impact and crack repairs too.
Learn more →
EVA teak
Cut on the CNC from an exact template of your boat, finished in the workshop, fitted on board in one go. Low-maintenance, non-slip.
Learn more →
Paint & varnish
From touch-ups to full paint, from varnish to polishing. Half of a good paint job is preparation; we follow the manufacturer’s data sheet.
Learn more →
Engineering & design
Signed conversion plans and permit files, new boat design, calculations, production plans and construction supervision.
Learn more →From survey to handover
Four steps, a written document in your hand at each one; no surprises.
Every job starts on board: inspection, measurements and, where needed, a 3D scan. Risks are set out in a written report before work begins.
→ Photo survey report
An itemised written quote and a staged plan. If parts are to be made, the design and templates are prepared here.
→ Itemised quote and schedule
The work is done where it makes sense: in the marina where the yacht is berthed, or in our workshop.
→ Photo progress updatesStaged handover, a photo report and a 12-month warranty on workmanship and materials.
→ Handover record and 12-month warrantySelected work
Every job runs differently. These jobs are shown step by step, from survey to handover; the details are on the project pages. All project files →
Teak deck
See the project →Swim platform fairing and teak renewal
Composite
See the project →A new composite console hatch from a mould
EVA teak
See the project →EVA teak deck on a motor yacht: from 3D scan to fitting
Our workshop
In our Göcek workshop we scan, draw and cut, and get every part ready to fit on board.
210×366
cm CNC bed3D
Scanning & digital templates
For captains, owners and yacht managers
Send a photo.
Send a photo.
Get a quote.
A few photos and two lines are enough. We send a first assessment within two working days and an itemised quote after the survey.
+90 (543) 104 58 00